DAT100 RS485 WEIGHING ELECTRONICMEASSURING AMPLIFIER PAVONE SISTEM

Mã sản phẩm: DAT100 RS485

Tên thiết bị: DAT100 RS485 WEIGHING ELECTRONICMEASSURING AMPLIFIER PAVONE SISTEMI

Xuất xứ: Italia

Tình trạng: Còn hàng

Phân loại: Pavone Sistemi
Giá liên hệ
Ngoài ra có thể liên hệ thông qua Hotline: 028. 3636 8733 Hoặc gửi mail trực tiếp về: info@dpcvietnam.com

DPC VIỆT NAM CHUYÊN CUNG CẤP DAT100 RS485 WEIGHING ELECTRONIC MEASURING AMPLIFIER CỦA HÃNG  PAVONE SISTEMI

DAT 100 / RS485

Weighing - electronic measuring amplifier

  - High performance and long term reliability - "Snap-on" mounting on DIN rail (EN50022) - Configuration and calibration from the frontal panel, executed with the certificates of conversion or with known weights - 2 logical inputs and 2 relay outputs - Serial RS232 and RS485 outputs, ASCII and Modbus RTU protocols - The limited width allows to place a large number of transmitters within the automation housing - Conjunction with intrinsically safe barriers for use in hazardous areas

TECHNICAL CHARACTERISTICS DAT 100 / RS485

Power supply of converter:4 V (max 4 350 Ohm cells)
Measuring range:-4 ÷ + 4mV / V
Input sensitivity:00:02 V / division
Linearity:<0.01% FS
Temperature drift:<0.001% FS / ° C
Display:LED 5 digits, red (7 segments), height 7mm
Status LED:2 red
A / D converter:24 bit
Internal resolution:16,000,000 parts
Visible resolution:99,999 divisions visible on the net weight
Scale interval (adjustable):0001 ÷ 50
Filters:0.2 ÷ 25 Hz adjustable
Keyboard:3 mechanical buttons (below the red door)
Power supply of the device:24 VDC ± 10% - Power consumption 2W
Operating temperature:-10 ÷ + 50 ° C (max. Humidity 85% no condensation)
Storage temperature:-20 ÷ + 60 ° C
Logic outputs:2 optocoupler; each MAX 24 VDC / 100 mA
Logic inputs:2 optocoupler to 24 VDC PNP (external power supply)
Serial Outputs:RS232C half duplex with Modbus RTU or ASCII protocol, full duplex RS485 with Modbus RTU or ASCII protocol
Baud rate:2400 ÷ 115200 adjustable
Transmission distance:15 m
Analog Output:16 Bit optocoupler
Voltage:0 ÷ 5 / 10V (R min10 K Ohm)
Power:0/4 ÷ 20mA (R max 300 Ohm)
Linearity:<0.03% to FS
Temperature drift:<0.002% FS
Standard compliance:EN61000-6-2, EN61000-6-3 for EMC; EN61010-1 for Power Safety
Power supply:Terminal strips for 5:08 mm screws